Trane RTHC Installation Operation & Maintenance page 77

Table 15
Parameter Displayed
Ice Termination Setpoint/Source
Reset Chilled Water Setpoint/
Source
Evap Entering Water Temp
Condenser Entering Water Temp.
Condenser Leaving Water Temp
Current Limit Setpoint/Source
Active Current Limit Setpt/Setting
Source
Outdoor Air Temp
Time/Refrigerant Type
Refrigerant Monitor (option only)
Saturated Evap Refgt Temp
Compressor Discharge Temp
Compressor Starts/Running Time
Evap Refgt Pressure
Evap Approach Temp
Chilled Water Flow Switch Status
Saturated Cond Temp
Condenser Refrigerant Pressure
Condenser Approach Temp
Cond Water Flow Switch Status
The chiller operating modes display comes up first in
the standard report:
[Operating mode line 1]
[Operating mode line 2]
Line 1 (and 2 if needed) indicates a current condition
of the unit as shown in the following table (Table 16) .
In some cases, an associated timer or system
parameter will be displayed that assures the
transition to an expected mode is in progress,
particularly during the unit start-up sequence.
Installation, Operation and Maintenance
Sequence
Standard ASHRAE
Report Report
3 4
4
5 4
6 12
7 5
8
9
1
6
7
8
9
10
11
13
14
15
5 - 7