Clearing Diagnostics - Trane RTHC Installation Operation & Maintenance

pressed the second historic diagnostic screen is
displayed. The second historic diagnostic screen will
be:
[sn] occurred at HH:MM xm Mon xx, 199x
Historic Only, Reset At End Of Diag Menu
Up to 20 diagnostics will be displayed.

Clearing Diagnostics

At the end of the diagnostic menu, four screens will
allow you to Clear/Reset the different diagnostic
groups.
If any active diagnostics are present, the following
screen will be displayed:
Press (Enter) To Clr Active Diagnostics
And Shutdown / Reset System
If the <Enter> key is pressed, the following message
is displayed for 2 seconds:
Active Diagnostics Have Been Cleared
System Is Resetting
The display will be reset to the operating mode
screen of the chiller report after this message clears.
If any historic diagnostics are present, the following
screen will be displayed:
Press (Enter) To
Clear Historic Diagnostics
If the <Enter> key is pressed, the following message
is displayed for 4 seconds:
Historic Diagnostics Have Been Cleared
Diagnostic Report Is Being Reset
The display will be reset to the top of the Diagnostic
Menu after this message clears.
5 - 38
If any IPC refrigerant monitor diagnostics are
present, the following screen will be displayed:
Press (+) To
Silence Rfgt Monitor Audible Alarm
NOTE: Pressing (+) will silence the audible alarm.
If the <+> key is pressed, the following message is
displayed for 4 seconds:
Silencing Rfgt Monitor Audible Alarm;
Clearing Nonactive Rfgt Alarms
RTHC-IOM-1C