Serial Interface Com1 (Rs232); Optional: Serial Interface Com2 (Rs232) - ADS-tec VMT9000 Series Instruction Manual

VMT9000 series − Instruction manual v1.2

5.4.5 Serial interface COM1 (RS232)

Interface
COM1
5 V voltage supply
The hardware switch marked
supplying power to serial bar code scanners).
Please note: In addition, the corresponding software switch in the
Configuration Center must be set to ON, see module Serial port data forwarding.

5.4.6 Optional: serial interface COM2 (RS232)

Interface
COM2
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
IRQ
5
(The figure shows the socket inside the device)
red in the picture is used to apply a voltage of +5 VDC at pin 9 (e.g. for
IRQ
6
Address
3F8h
Address
2F8h
26