Environmental Conditions - ADS-tec VMT9000 Series Instruction Manual

VMT9000 series − Instruction manual v1.2

2.4 Environmental conditions

ATTENTION
Damage caused by heat!
If the device is exposed to sunlight or any other light or heat source, it can overheat and suffer
damage.
 Do not expose the device to direct radiation by sunlight or any other light or heat source!
ATTENTION
Damage caused by heat!
If the device is installed in a panel, casing or similar, heat accumulation can occur.
 Make sure that heat can be dissipated from the device!
ATTENTION
Damage caused by condensation!
If the temperature of the device is different to that of the environment in which it is located,
condensation can form.
 Switch on the device only after it has acclimated to the ambient temperature!
The device can be operated under the environmental conditions specified in the technical data. Failure
to observe any one of these conditions will invalidate the warranty of the device. ADS-TEC cannot be
held liable for any damages arising from improper use and handling.
Vibration and shock resistance
The device complies with class 5M3 as defined in EN 60721-3-5 (environmental conditions in the case
of devices for ground vehicles).
Tests were conducted in accordance with the following test standards:
• EN 60068-2-6 – Sinusoidal vibration (2...500 Hz, 30 m/s² peak, 2 h per axis)
• EN 60068-2-27 – Shock resistance (400 m/s², 6 ms, 1000 shocks per direction and axis)
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
11