Flight Medical Innovations 60 Series Service Manual page 65

4. Disconnect the solenoid cable from the solenoid board (P1). If it's hard to reach
you can remove the screws that secure the front panel and move the front
panel so gain better access.
5. Disconnect the 3 silicon tubes from the solenoid assembly.
Figure 63 – Disconnecting Silicon Tubes
6. Unscrew the two adjacent Torx screws on the solenoid bracket. Pull out the
bracket with the solenoid, carefully leading the solenoid cable, making sure it
is not being damaged
Figure 62 –Solenoid Cable connector
Removing and Reinstalling Modules
Replacing the Solenoid Assembly
Flight 60 Service Manual | 4-35