Start-Up And Power Loss - Zennio MAXinBOX FC 0-10V FAN User Manual

MAXinBOX FC 0-10V FAN
For detailed information about the technical features of the device and for safety
instructions and on the installation process, please refer to the Datasheet bundled with
the original packaging of the device and also available at www.zennio.com.

1.3 START-UP AND POWER LOSS

During the start-up of the device, the Test/Prog. LED will blink in blue colour for a few
seconds before MAXinBOX FC 0-10V FAN is ready. External orders will not be
executed during this time, but afterwards.
Depending on the configuration, some specific actions will also be performed during
the start-up. For example, the integrator can set whether the outputs should switch to a
particular state and whether the device should send certain objects to the bus after the
power recovery. Please consult the next sections of this document for further details.
On the other hand, when a bus power failure takes place, MAXinBOX FC 0-10V FAN
will interrupt any pending actions, and will save its state so it can be recovered once
the power supply is restored.
http://www.zennio.com Technical Support: http://support.zennio.com
8