Downloading File From Ftp Server - Multitech MultiConnect Cell 100 Series User Manual

CONFIGURING AND COMMUNICATING WITH YOUR DEVICE
6. Configure file transfer type.
Enter:
AT#FTPTYPE=#
where # is 0 for binary or 1 for ASCII.
7. Enter the file name to be sent to the FTP server and initiate connection.
Enter:
AT#FTPPUT="file.txt"
The device responds with:
CONNECT
8. Send the file through the device.
Closing the FTP Data Connection
After the file is sent:
1. Enter the escape sequence.
Enter:
+++
The device responds with:
NO CARRIER
2. Close the FTP connection.
Enter:
AT#FTPCLOSE
3. Close the PPP data connection.
Enter:
AT#SGACT=1,0
The device responds with OK.

Downloading File from FTP Server

To connect to an FTP server and download files:
1. Check signal strength.
Enter:
AT+CSQ
2. Verify device is registered on the cellular network.
Enter:
AT+CEREG?
Should return:
+CEREG: 0,1 or +CEREG: 0,5
OK
3. Activate context one
Enter:
AT#SGACT=1,1
4. Set FTP operations timeout to 10 seconds
26
®
MultiConnect Cell MTC-MNA1 User Guide