Downloading File From Ftp Server - Multitech MultiConnect Cell MTC-H5 User Manual

AT#FTPTYPE=# where # is 0 for binary or 1 for ASCII.
6. Enter the file name to be sent to the FTP server and initiate connection.
Enter:
AT#FTPPUT="file.txt"
The device responds with:
CONNECT
7. Send the file through the device.
Closing the FTP Data Connection
When you finish sending the file:
1. Enter the escape sequence.
Enter:
+++
The device responds with:
NO CARRIER
2. Close the FTP connection.
Enter:
AT#FTPCLOSE
3. Close the PPP data connection.
Enter:
AT#SGACT=1,0
The device responds with OK.

Downloading File from FTP Server

To connect to an FTP server and download files:
1. Check signal strength.
Enter:
AT+CSQ
2. Activate context one
Enter:
AT#SGACT=1,1
3. Set FTP operations timeout to 10 seconds
Enter:
AT#FTPTO=1000
4. Configure FTP server IP address with username and password.
Enter:
AT#FTPOPEN="###.##.###.#","username","password",0 where ###.##.###.# is the IP address and the
username and password for the FTP server.
5. Configure file transfer type.
Enter:
AT#FTPTYPE=# where # is 0 for binary or 1 for ASCII.
®
MultiConnect Cell MTC-H5 User Guide
CONFIGURING AND COMMUNICATING WITH YOUR DEVICE
29