Changing The Time Settings In Lhmi; Saving Settings - ABB Relion 630 Series Operation Manual

1MRS756509 E
4.1.12.4
4.1.13
630 series
Operation Manual
When editing an enumerated value, the selected value is shown inverted.
2.
Press or to change the value of an active enumerated value.
One press changes the enumerated value by one step in the parameter specific
order.

Changing the time settings in LHMI

1. Select Main menu/Configuration/Time/System time.
The change takes effect immediately.
2.
Press to confirm the selection.
•
Press to remove the changes.

Saving settings

Editable values are stored in the non-volatile flash memory. Most of the parameter
changes take effect immediately after storing, but some parameter changes require
application restart. Values stored in the flash memory remain in effect after reboot as
well.
1.
Press to confirm any changes.
2.
Press to move upwards in the menu tree or
3.
To save the changes in non-volatile memory, select Yes and press
A071206 V2 EN
Figure 27: Confirming settings
•
To exit without saving changes, select No and press
•
To cancel saving settings, select Cancel and press
Pressing Cancel in the Save changes dialog closes only the Save
changes dialog box, but the IED remains in editing mode. All the
changes applied to any setting are not lost and the user can continue to
change settings. To leave the change setting mode, select No or Yes
in the Save changes dialog.
Section 4
Using the HMI
to enter the Main Menu.
.
.
.
45