Editing Numerical Values - ABB Relion 630 Series Operation Manual

1MRS756509 E
4.1.12.1
630 series
Operation Manual
Parallel editing is not possible. For example, if a value is edited via
WHMI or PCM600, the same value cannot be edited via LHMI at the
same time.

Editing numerical values

1. Select Main menu/Settings and then a setting.
The # character on the right indicates that the parameter belongs
to a setting group.
The last digit of the value is active.
• When the symbol in front of the value is ↑, the active value can only be
increased.
• When the symbol is ↓, the active value can only be decreased.
• When the symbol in front of the value is ↕, the active value can either be
increased or decreased.
A071202 V3 EN
Figure 25: Last digit is active and it can be increased or decreased
2.
Press to increase or
One press increases or decreases the value by a certain step. For integer values,
the change is 1, 10, 100 or 1000 (...) depending on the active digit. For decimal
values, the change can be fractions 0.1, 0.01, 0.001 (...) depending on the active
digit.
to decrease the value of an active digit.
Section 4
Using the HMI
43