Clearing And Acknowledging; Selecting The Event View - ABB Relion 630 Series Operation Manual

Section 4
Using the HMI
4.2.8
4.2.9
54
A071252 V2 EN
Figure 39: Committing changes
Committing values takes a few seconds.
If the values are not committed, they are not taken into use and they are
lost after a reboot. However, in case of changing the time settings in
WHMI, the change takes effect immediately without committing the
changes.

Clearing and acknowledging

Reset, acknowledge or clear all messages and indications, including LEDs and latched
outputs as well as registers and recordings, in the Clear menu.
1. Click the Clear menu.
2. In the New Value box, click Clear to select the item to be cleared.
3. Click Write to IED.

Selecting the event view

The event view contains a list of events produced by the application configuration.
The default view shows the latest events. The event list is updated if the event count
1MRS756509 E
630 series
Operation Manual