1MRS756509 E
4.2.7
630 series
Operation Manual
If writing is enabled accidentally, click Disable Write. Disable Write cannot be
selected, when a value has already been written to the IED. After clicking Write to
IED, click either Commit or Reject.
Committing settings
Editable values are stored in the non-volatile flash memory. Values stored in the flash
memory are in effect also after reboot.
1.
Edit setting values.
2.
Click Write to IED.
The values are written into the IED, but not taken into use.
A071250 V2 EN
Figure 38:
Writing values to the IED
3.
Commit or reject new values.
•
Click Commit to save the values.
The new values are saved in the non-volatile memory and taken into use.
•
Click Reject to cancel saving the settings.
Section 4
Using the HMI
53