Table of Contents
Advertisement
Chapter 5 - Ports and Connectors
Front Panel I/O Ports
COM 4 (RS232) / 8-bit DIO
CANbus
(RS232/RS422/RS485)
The front I/O panel consists of the following ports:
•
Control and status panel
- Power LED (green)
- Status LED (blue)
- A reset switch
•
Display output
- HDMI port
•
USB 3.0 port
•
Three serial ports:
COM 1 and 2 are RS232/RS422/RS485 ports
COM 4 can be a serial or an 8-bit DIO port*
Note:
You can also choose to configure the COM 4 port to be a CANbus (Controller Area
Network) interface instead.
Chapter 5 Ports and Connectors
Chapter 5
Antenna
hole
COM 2/1
Power LED
USB 3.0
HDMI
Reset switch/
Status LED
Rear Panel I/O Ports
LAN 2
LAN 1
USB 2.0
Line-out
The rear I/O panel consists of the following ports:
•
Two serial ports
- RS232/RS422/RS485 port
- RS232 port
•
Display output
- VGA port
•
Audio output
- Mic-in
- Line-out
•
Three USB 2.0 ports
•
Two LAN ports
•
Power connector (with ignition control)
18
VCC/ACC/GND
(Connects to car battery)
Mic-in
COM 5
(RS232)
VGA
COM 3
(RS232/RS422/RS485)
Advertisement
Table of Contents
