Table of Contents
Advertisement
Chapter 3 - Installing Devices
Removing the Chassis Cover
Please observe the following guidelines and follow the procedure to open the system.
1.
Make sure the system and all other peripheral devices connected to it have been powered
off.
2.
Disconnect all power cords and cables.
3.
The 12 mounting screws on the bottom and two sides of the system are used to secure the
cover to the chassis. Remove these screws and then put them in a safe place for later use.
4.
After removing the mounting screws, lift the bottom side of the chassis cover to open the
system. The Mini PCIe and the micro SD slots will be readily accessible.
5.
The Mini PCIe and the micro SD (optional) slots are readily accessible after removing the
chassis cover.
Chapter 3 Installing Devices
Chapter 3
Chassis screw
Mini PCIe slots
micro SD
11
Installing a SATA Drive
The system can accomondate one SATA drive. Please use the following procedure to install a
SATA drive into the system.
1.
The SATA data and power connectors are on the system board beneath the power board.
Please remove the power board first to take out the SATA HDD bracket.
2.
Align the mounting holes of the SATA drive with the mounting holes on the SATA HDD
bracket and use the provided mounting screws to attach the SATA drive to the bracket.
Power board
Power board
Mounting screws
SATA HDD bracket
Mounting screws
SATA
Mounting screws
www.dfi.com
Advertisement
Table of Contents
