Chapter 5 - Ports And Connectors; Front Panel I/O Ports; Rear Panel I/O Ports - DFI VC230-AL User Manual

Chapter 5 - Ports and Connectors

Front Panel I/O Ports

Power LED
GPIO
Reset
Speaker
The front panel I/O consists of the following ports:
• Power LED (green)
• HDD LED (blue)
• Reset Switch
• DVI-I Connector
• HDMI
• 8-bit GPIO Connector
• CAN Bus Port (optional)
• 4-pin Speaker Connector
Note:
The HDMI is a DP/HDMI combo port but can only transmit HDMI signals. Please plug in an HDMI cable
with the right orientation and alignment to avoid damage to the connector. Please see a video at
https://youtu.be/SUj07rfN5l8 for detailed instructions.
angled-corner
aligning side
User's Manual | VC230-AL
HDD LED
DVI-I
HDMI*
CAN Bus
Align this edge with the left side
of the connector

Rear Panel I/O Ports

Built-in GPS
receiver antenna
COM 1
Remote
Power-on Switch
FME
Antenna
hole
The rear panel I/O port consists of the following ports:
• 3-pin DC-in power connector
• RS232/RS422/RS485 port (COM1)
• Remote power-on switch
• Two USB 2.0 Ports & 3.0 Ports
• Two LAN ports
• Built-in GPS receiver antenna (SMA type) & FME type antenna holes
Chapter 5
LAN 1 LAN 2
USB 2.0
Grounding
USB 3.0
VCC/IGN/GND
(Connects to car battery
and power ignition)