DFI VP101-BT User Manual page 39

Fanless in-vehicle panel pc system with touchscreen
Hide thumbs Also See for VP101-BT:
Table of Contents

Advertisement

Updating the BIOS
To update the BIOS, you will need the new BIOS file and a flash utility. Please contact techni-
cal support or your sales representative for the latest BIOS file and the firmware update utility.
For instructions on how to update BIOS with the flash utility, please see
knowledge/video/5
from the Knowledge Base of the DFI website.
C:\AFU\AFUDOS>afudos filename /B /P /N
+--------------------------------------------------------------------------------------------------------+
|
AMI Firmware Update Utility(APTIO) v2.25
|
Copyright (C)2008 American Megatrends Inc. All Rights Reserved.
+--------------------------------------------------------------------------------------------------------+
Reading file ..............................
done
Erasing flash .............................
done
Writing flash .............................
done
Verifying flash ..........................
done
Erasing BootBlock ....................
done
Writing BootBlock ....................
done
Verifying BootBlock .................
done
C:\AFU\AFUDOS>
Chapter 7 BIOS Setup
Chapter 7
Notice: BIOS SPI ROM
1. The Intel
the safety concerns, the BIOS (SPI ROM) chip cannot be removed from this system board
https://www.dfi.com/
and used on another system board of the same model.
2. The BIOS (SPI ROM) on this system board must be the original equipment from the factory
and cannot be used to replace one which has been utilized on other system boards.
3. If you do not follow the methods above, the Intel
updated and will cease to be effective.
|
|
39
Management Engine has already been integrated into this system board. Due to
®
®
Note:
a. You can take advantage of flash tools to update the default configuration of the
BIOS (SPI ROM) to the latest version anytime.
b. When the BIOS IC needs to be replaced, you have to populate it properly onto the
system board after the EEPROM programmer has been burned and follow the
technical person's instructions to confirm that the MAC address should be burned
or not.
Management Engine will not be
|
|
www.dfi.com

Advertisement

Table of Contents
loading

Table of Contents