Table of Contents
Advertisement
Getting to Know the VP101-BT
Top View
COM 4 (RS232/422/485) / 8-bit DIO
CANbus
(RS232/RS422/RS485)
Power LED (Green)
This button only indicates power-on or power-off status. Note that this button cannot
be used to power on or off the system; please power on or off the system via car
ignition.
Status LED (Blue)
Indicates system status.
Status LED
Suspend Mode
S0
LED Behavior
Off
Reset Switch
Press to restart the system without going through a full shutdown and boot cycle.
HDMI Port
Connects to the HDMI port of a display.
USB 3.0 Port
Connects USB 3.0 devices as well as devices from previous versions such as USB 2.0
or USB 1.1.
COM Ports
COM 1, COM 2 and COM 4 can be an RS232, RS422 or RS485 port. COM 4 can be
used as an 8-bit Digital I/O, a serial or CANbus port via jumper selection.
Wireless Antenna Holes
Reserved for installing wireless antennas.
Chapter 1 Introduction
Antenna
hole
COM 2/1
Power LED
USB 3.0
HDMI
Reset switch/
Status LED
S1-S3 (sleep)
S4, S5
Blinking
Off
Chapter 1
Bottom View
LAN 1 MIC-in
LAN 2
Power Connector
Connects a car battery for power supply.
LAN Ports
Connect a network device or a LAN cable for network connectivity.
USB 2.0 Ports
Connect USB 2.0 or 1.1 devices.
Line-out
Connects a speaker.
Mic-in
Connects a microphone.
COM Ports
Connect serial devices. COM 3 can be an RS232, RS422 or RS485 port; COM 5 can
only be an RS232 port.
VGA
Connects the VGA port of a display device.
8
VCC/ACC/GND
(Connects to car battery)
COM 5
USB 2.0
(RS232)
VGA
Line-out
COM 3
(RS232/RS422/RS485)
www.dfi.com
Advertisement
Table of Contents
