Preliminary Check; Hot Water - Sanremo CAPRI SAP Instruction Booklet

Hide thumbs

Table of Contents

ENGLISH

3) Connect the drain hose to the tray, avoiding sharp bends and keeping a sufficient slope for regular

flow of the drain water.

4) Connect the 3/8" hose to the mains outlet and then to the water softener and to the appliance.

N.B. A water softener is indispensable for correct appliance operation, best coffee in the cup and long

life of the components, since it removes scale and residues from the water that would otherwise shorten

their life.

The company is relieved of all and any liability in the event of failure to comply with the

above instructions.

Before using the appliance, check that:

- the plug is inserted properly into the mains power outlet;

- the water filling hose is correctly connected to the mains water outlet, check for leaks and that the water

tap is open;

- the drain pipe is positioned in accordance with the preceding instructions.

With a steam tap (B) open, put the on/off switch (D) to position 1 and wait for the water in the boiler to

reach the maximum level set by the electronic control. If the boiler does not fill within the set time-out

(90 sec.), the pump stops and the indicator lights on the keypad start to blink. In this case put the on/off

switch (D) to position 0 and then to position 1 to finish filling the boiler.

Now put the on/off switch (D) to position 2 so that the heating elements are powered and therefore start

to heat the water.

Wait for steam to come out the steam nozzle (B), then close the tap and, using the Boiler pressure

gauge, check that the pressure has reached and maintains a value of 0.8:1 bar. If it is not on this value,

turn the adjusting screw on the pressure switch (+increase, - decrease, see figure below).

Ensure that the boiler pressure gauge indicates a pressure of 0.5:1 bar. Turn the tap knob (C) counter-

clockwise.

Pay the utmost attention in order to prevent scald burns.

Except for the 1-group machine that has just one steam nozzle, all the other models have 2 located

at the sides. These steam nozzles are recessed but can swivel out thanks to an articulated joint. To

dispense steam, just turn the knobs (B) counter-clockwise.

Pay the utmost attention in order to prevent scald burns.

Insert the filter holder (E) into the group head (F) turning the filter holder counter-clockwise. Press button

(I), wait for the required quantity of coffee to be dispensed and then put it back to its original position.

USE