Preliminary Check; Hot Water - Sanremo Amalfi DLX SED Instruction Booklet

ENGLISH
- the drain pipe is positioned in accordance with the preceding instructions.
Now put the on/off switch (D) to position 2 so that the heating elements are powered and therefore start to heat the water.
Ensure that the boiler pressure gauge indicates a pressure of 0.5:1 bar. Turn the tap knob (C) counter-clockwise. Pay the utmost attention in
order to prevent scald burns.
Insert the filter holder (E) into the group head (F) turning the filter holder counter-clockwise. Select the type of dispensing required on the
keypad (M):
M1=One strong/normal coffee.
M2=One normal/weak coffee.
M3=Two strong/normal coffees.
M4=Two normal/weak coffees.
M5=Electronic programming key or continuous manual dispensing.
M5 start to blink continuously. Select the caption corresponding to the amount required and press to dispense. The indicator light of button
that the control unit stores the data. Repeat the above procedure for all 4 dispensing buttons on the pushbutton panel. A dispensed quantity
c) The AMALFI DLX SED electronics also offers the possibility of reproducing the pre-brewing effect by wetting the coffee for 0.6 seconds and
then stopping the subsequent brewing from starting for 1.2 seconds. This optional is only applicable for single shots of coffee.
USE

Preliminary check

Hot water

Steam
Pay the utmost attention in order to prevent scald burns.
Coffee with Mod. AMALFI DLX SED
DISPENSER PROGRAMMING
To enable pre-brewing
21