Help Guide
Linear PCM Recorder
PCM-D10
List of messages
HOLD... Slide HOLD Switch to Activate.
All the buttons are disabled because your linear PCM recorder is in the HOLD state to prevent unintentional operations. Slide
the HOLD switch to [OFF] to release the linear PCM recorder from the HOLD state.
(See
Releasing the linear PCM recorder from the HOLD
Low Battery Level
You cannot format the memory or delete all the files in a folder because of insufficient battery power. Replace the batteries with
new ones.
(See
Inserting
batteries.)
Low Battery
The remaining battery power is not enough for the linear PCM recorder to operate. Replace the batteries with new ones.
(See
Inserting
batteries.)
SD Card Error
An error was detected when you inserted a SD card into the SD card slot. Remove the SD card and insert it once again. If this
message keeps appearing, use a new SD card.
This SD Card Not Supported
An incompatible SD card is in use. Check on the SD cards that are compatible with the linear PCM recorder.
(See
Compatible SD
cards.)
Cannot Write to This SD Card
The write-protect switch on the card is placed in the [LOCK] position. Release the write-protect setting.
Memory Full
The remaining capacity of the built-in memory is insufficient. Delete some files and repeat the recording once again.
(See
Deleting a
file.)
File Full
The sum of folders and files or the total number of files has reached the limit. You cannot create any more files. Delete some
files and create the file once again.
(See
Deleting a
file.)
Settings are Full
The folder name you selected is already used. Change the folder name.
(See
Changing a folder
name.)
Track Marks are Full
The number of track marks has reached the limit. You cannot add any more track marks. Delete some unnecessary track marks.
(See
Deleting a track
mark.)
Built-In Memory Needs to be Formatted / SD Card Needs to be Formatted
The built-in memory or the SD card has been formatted by a computer. Your linear PCM recorder cannot create the required
management file for operations. Make sure that you use the linear PCM recorder, not a computer, to format the built-in
memory or the SD card.
(See
Formatting the memory (Format Built-In Memory/Format SD
The built-in memory or the SD card does not contain the REC_FILE folder. Formatting the built-in memory or the SD card
automatically creates the REC_FILE folder.
state.)
Card).)
219