Sony PCM-D10 Help Manual page 101

Linear pcm recorder
Hide thumbs Also See for PCM-D10:
Table of Contents

Advertisement

Help Guide
Linear PCM Recorder
PCM-D10
Establishing a Bluetooth connection with the one-touch operation (NFC connection)
If a smartphone has the NFC function, follow the steps below to establish a Bluetooth connection between the smartphone and
your linear PCM recorder.
Turn on your linear PCM recorder.
1
While recording is in progress or paused or the linear PCM recorder is paused for recording, you cannot establish a
connection with the one-touch operation. Before establishing the connection, make sure that recording is on standby.
On the smartphone, turn on the NFC function.
2
Start REC Remote.
3
Put the smartphone onto your linear PCM recorder aligning the
4
Keep the smartphone on the linear PCM recorder until the [Bluetooth pairing request] screen appears on the smartphone,
and then select [Pair].
When the operation screen of REC Remote appears on the smartphone, the Bluetooth connection should be successfully
established.
Proceed to
Using the smartphone for linear PCM recorder
Hint
During a pairing attempt, [Bluetooth pairing request] may appear in [Notifications] on the smartphone. View the [Notifications] list and tap
[Bluetooth pairing request] and then select [Pair].
If the Bluetooth connection is not established, try the following:
Keep the smartphone touched on the
around.
Check if the NFC function of your linear PCM recorder is turned on. Select [
make sure that [ON] is selected.
If the smartphone is in a smartphone case, remove the case and perform the above steps all over again.
If neither of the above works, try the steps in
recorder.
What is NFC?
NFC (Near Field Communication) is a technology that enables short-range wireless communications between various devices,
including mobile telephones and IC tags. You can exchange data by simply putting a device onto the designated area on
another device.
With an NFC-enabled smartphone, you can simply put it onto the
connection by pairing both devices with the NFC function. You can also disconnect or switch the Bluetooth connection in the
same manner.
operations.
mark on your linear PCM recorder and slowly move the smartphone back and forth and
Establishing a Bluetooth connection between the smartphone and the linear PCM
101
marks on both devices with each other.
Bluetooth] - [NFC Settings] from the HOME menu and
mark on the linear PCM recorder to establish a Bluetooth

Advertisement

Table of Contents
loading

Table of Contents