Place A Call On Hold With Call Park - Cisco 7832 User Manual

Calls
A parked call is monitored by your network so you won't forget about it. If the call remains parked for too
long, you hear an alert. You can then answer, decline to answer, or ignore the call on your original phone.
You can also continue retrieving it from another phone.
If you don't answer the call within a certain length of time, it's routed to voicemail or another destination, as
set by your administrator.

Place a Call on Hold with Call Park

You can park an active call that you answered on your phone and then use another phone in the call control
system to retrieve the call.
You can also park a call on your own phone. If so then you may not hear a recording.
You can park only one call at the call park number.
Before You Begin
Your call must be active.
Procedure
Step 1
Press Park.
Your phone plays a recorded message that asks for the number of the parked call.
Step 2 Enter the number and press Pound(#).
Step 3
(Optional) Communicate the parked number to the person retrieving the call.
Retrieve a Call on Hold with Call Park
You can pick up a parked call from anywhere in your network.
Before You Begin
You need the number that was used to park the call.
Procedure
Step 1 Press Unpark.
Step 2 (Optional) Press the line key that has busy lamp field with call pickup configured to retrieve a call on hold.
Step 3
Enter the number where the call is parked followed by Pound(#).
You can also enter Pound(#) to retrieve the parked call. If you retrieve a call parked on your own phone, you
may not need to enter a number.
Cisco IP Conference Phone 7832 Multiplatform Phone User Guide
Call Park
25