Hold Calls; Put A Call On Hold; Answer A Call Left On Hold For Too Long - Cisco CP-8832 User Manual

Hold Calls

If you mute one expansion microphone, the caller can still hear audio from the other expansion microphone
Note
and from the base unit. To mute the entire phone, press Mute
Procedure
Step 1
Press Mute
Step 2
Press Mute
Draft comment: Question for Doc Team: The mute button on the expansion mic doesn't look exactly like
the mute button image shown. It is round instead of the standard square button. Do I need to generate a new
graphic specifically for the round mute button on the expansion mic, or is this close enough?

Hold Calls

Put a Call on Hold

You can put an active call on hold and then resume the call when you're ready.
Procedure
Step 1
Step 2 To resume a call from hold, press Resume.

Answer a Call Left on Hold for Too Long

When you leave a call on hold too long, you are notified with these cues:
• Single ring, repeating at intervals
• Flashing LED bar
• Visual notification on the phone screen
Cisco IP Conference Phone 8832 User Guide
18
REVIEW DRAFT - CISCO CONFIDENTIAL
on the expansion microphone.
again to turn mute off.
Calls
on the base unit.