Display; Set All Settings To Factory Default; Fixture Test - Martin ELP CL User Manual

To set the fixture's dimmer curve, select DIMMER CURVE from the PERSONALITY menu and
press ENTER to confirm. Use the UP and DOWN buttons to select the desired mode. Press
ENTER to save your selection.
PWM Frequency
Sets the frequency of the PWM dimming used on the fixture. It can sometimes be necessary to
change this if flickering is seen on TV cameras running at a high shutter speed.
The setting is 600Hz to 1200Hz, the default is 1200Hz.
No Data Mode
This option sets what will happen when DMX data is not present.
To set No Data Mode, select NO DATA MODE from the PERSONALITY menu and press ENTER
to confirm. Use the UP and DOWN buttons to select:
BLACKOUT – If data connection is lost, fixture will blackout
HOLD – If data connection is lost, fixture holds latest received data value at all channels (default)
Press ENTER to confirm.
Cooling Mode
This option sets whether the cooling fans run at full speed all the time or are controlled by fixture
output power.
To set cooling mode, select COOLING MODE from the PERSONALITY menu and press ENTER
to confirm. Use the UP and DOWN buttons to select:
REGULATED FANS – Fan speed will be controlled by heat demand in the fixture.
FULL – Fans set to full constant speed.
LOW – Fans set to constant low speed
Press ENTER to confirm.

Display

This option allows you to set some parameters for the display screen.
Select DISPLAY from the PERSONALITY menu and press ENTER to confirm.
Use the UP and DOWN buttons to select:
•
DISPLAY SLEEP – Use the UP and DOWN buttons to select display sleep time, settings are
ON (Display permanently on), 2 MINUTES, 5 MINUTES or 10 MINUTES
•
DISPLAY ROTATION –Use the UP and DOWN buttons to select Normal (Display orientation
normal) or ROTATE 180 (Display orientation rotated 180°)
•
DISPLAY INTENSITY –Use the UP and DOWN buttons to adjust display intensity from 10%-
100% (default = 100%)
•
TEMPERATURE UNIT – Use the UP and DOWN buttons to select °C or °F
Press ENTER to confirm.

Set all settings to factory default

To return all settings to factory default, select DEFAULT SETTINGS and press ENTER to confirm,
FACTORY DEFAULT will show on the display. Press ENTER again.
Use the UP and DOWN buttons to select NO (cancel) or YES (return all settings except
calibrations to factory defaults).
Press ENTER to confirm (or press MENU to exit without making a change).

Fixture test

This menu allows you to run self-test sequences on the fixture's LED emitters. Each color of
emitters will be switched on in turn.
Martin ELP CL Profile user guide 17