Setting The Thumbnail Image - Sony XDCAM PDW-510 Operation Manual

5-7 Setting the
Thumbnail Image
When the unit is shipped from the factory, it is set up to
display the first frame of a clip as the clip's thumbnail
image (see page 60). As required, you can select another
frame to display as a clip's thumbnail image.
For example, if all clips have the same image in their first
frames, you can specify a frame a few seconds after the
start of the clip, so that all thumbnails will not show the
same image.
To select the frame to display as a clip's
thumbnail image
Proceed as follows.
1
Turn the POWER switch on.
2
Holding down the MENU knob, move the MENU ON/
OFF switch to ON.
The TOP menu appears.
3
Turn the MENU knob to move the b mark to
"MAINTENANCE".
4
Press the MENU knob.
If this is the first time the MAINTENANCE menu has
been displayed, the CONTENTS page of the
MAINTENANCE menu appears. If the menu has been
used before, the last accessed page appears.
5
If the CONTENTS page is displayed, turn the MENU
knob to move the b mark to "ESSENCE MARK",
then press the MENU knob.
If a different page is displayed, turn the MENU knob
until the ESSENCE MARK page appears, then press
the MENU knob to select the page.
6
Press the MENU knob, then turn it to move the b mark
to "INDEX PIC.POS.", and press the MENU knob
again.
The b mark changes to a z mark, and the z mark
changes to a ? mark.
92

5-7 Setting the Thumbnail Image

?M10 ESSENCE MARK
SHOT MARK 1
SHOT MARK 2
OVER AUDIO LIMIT :
GAIN CHG. MARK
FILTER CHG. MARK :
SHUTTER CHG. MARK:
WHITE CHG. MARK
FLASH MARK
FLASH MARK LEVEL :
INDEX PIC. POS.
7
Turn the MENU knob to select the desired time.
8
Press the MENU knob.
The selection is confirmed.
9
Set the MENU ON/OFF switch to OFF to end the
menu operation.
TOP
: OFF
: OFF
OFF
: OFF
OFF
OFF
: OFF
: OFF
10
:? 0SEC