Sony XDCAM PDW-510 Operation Manual page 104

Extended commands
The following table shows the extended FTP commands
supported by this unit.
Command name
SITE REPF
SITE FSTS
SITE MEID
SITE FUNC
SITE UMMD
104
6-3 FTP File Operations
Description
Sends an MXF file from the specified
path on this unit to the remote
computer. This command allows you to
specify a segment in the body of the
MXF file (composed of video and audio
data), for transfer of the required
segment only.
Note
A segment greater than the file size
cannot be specified.
Acquires the system status of this unit.
One of the following status codes is
sent.
0: Initial state, or no disc is loaded.
1: File system mount is OK.
3: File system mount is not OK.
Acquires the media ID of the disc
loaded in this unit.
Acquires the function and version of the
expanded commands.
Information is sent in the following
format.
<main function> <SP> <branch
function> <SP> <branch function
version>
For XDCAM, sent in a format like "200
MXF DISK 1" (200 is a response code).
When C*.MXF file (*: 0001 to 0300) is
sent with the STOR, the copy source
UMID is saved if this command is
invoked immediately before the STOR
command.
In the command syntax column, <SP> means a space,
entered by pressing the space bar, and <CRLF> means a
new line, entered by pressing the Enter key.
Command syntax
SITE REPF <SP> <path-name> <SP> <start-frame> <SP>
<transfer-size> <CRLF>
<start-frame> specifies an offset from the start of the file.
Data is transferred from the video frame at the offset (the first
frame is 0).
<transfer-size> specifies the number of video frames to
transfer (specify 0 to transfer to the end of the file).
Input example: SITE REPF Clip/C0001.MXF 5 150 (Transfer
C0001.MXF. Body data is transferred only from frame 6 to
frame 155.)
SITE FSTS <CRLF>
SITE MEID <CRLF>
SITE FUNC <CRLF>
SITE UMMD <CRLF>