recorded, the retake function does not work even when the
camcorder is in the recording pause state.
In this case, the message "RE-TAKE NOT ALLOWED!"
appears. When you want to replace the last clip with a new
clip, see 3-2-2 "Deleting Clips" (page 48). Once you carry
out a retake operation, the last clip is deleted even if you
do not carry out a recording operation afterwards.
3-2-7 Auto Clip List Recoding for
Automatic Inclusion of
Recorded Clips in Clip Lists
Auto clip list recoding is a function for automatically
including the clips generated by recording operations in a
selected clip list. The updated clip list is saved to the disc.
Proceed as follows.
Insert a disc.
Load a clip list from the disc.
• To create a new clip list, load a NEW FILE (empty)
• To add clips to an existing clip list, load that clip list.
Always load either a new or existing clip list from disc.
For operations, see 4-3-3 "Loading a Clip List From
Disc Into the Current Clip List" (page 72).
Press the SUB CLIP button, turning on the sub clip
The camcorder enters auto clip list recording mode.
The viewfinder screen shows the number of the clip
list loaded in the current clip list.
The number of the clip list loaded in the current clip list
Press the REC START button or the VTR button on
the lens to start recording, and press again to stop
A clip is generated automatically from the video and
audio recorded in this interval, and added as a sub clip
to the the currently loaded clip list. The updated list is
also written to disc automatically.
Repeat the process of recording and stopping until you
have included all the required clips.
To change target clip lists, carry out step 2 once more
to load the desired clip list into the current clip list.
To exit auto clip list coding mode
Press the SUB CLIP button, turning off the sub clip