Sony XDCAM PDW-510 Operation Manual page 69

CLIP LIST LOAO
E0001 04/08/08 21:57
E0002 04/08/24 11:15
E0003 04/08/25 15:30
E0004 NEW FILE
E0005 NEW FILE
E0006 NEW FILE
E0007 NEW FILE
E0008 NEW FILE
E0009 NEW FILE
E0010 NEW FILE
3
Select the desired clip list (except for NEW FILE), and
press the SEL/SET dial or the MENU knob.
The message "LOAD OK? YES b NO" appears.
4
Turn the SEL/SET dial or the MENU knob to move the
b mark to "YES" and press the dial/knob.
The selected clip list is loaded into the current clip list.
5
Hold down the SHIFT button and press the SUB CLIP
button.
CLIP menu operations end.
Moving a sub clip
Proceed as follows.
1
Press the SUB CLIP button, turning on the indicator.
2
Press the THUMBNAIL button, turning on the
indicator.
Thumbnails of the sub clips within the current clip list
appear.
Notes
• If the MENU ON/OFF switch is set to ON, set it to
OFF and press the THUMBNAIL button.
• If you set the MENU ON/OFF to ON during
thumbnail display, thumbnail display is cancelled
and replaced with menu display.
To escape from the thumbnail display to the full-
screen display
Press the THUMBNAIL button, turning off the
indicator.
ESC
3
Use the SEL/SET dial or the MENU knob to select the
desired sub clip.
4
Hold down the SHIFT button, and press the SEL/SET
dial.
The sub clip operation menu appears.
To return to the thumbnail display without moving
the sub clip
Do either of the following.
• Use the SEL/SET dial or the MENU knob to select
• Press the RESET button.
5
Use the SEL/SET dial or the MENU knob to select
MOVE, and press the dial/ knob.
The sub clip movement screen appears. The sub clip
selected in step 3 appears surrounded by a frame.
To escape from the sub clip movement screen to the
previous screen
Press the RESET button.
EXIT, and press the dial/knob.
This shows that third sub clip is moved
to the position of eighth sub clip.
Cursor showing the position to which
the selected sub clip is moved
69
4-2 Basic Operations