3. Installation
3.1 Mounting
Depending on your installation requirements, you may wish to complete the network
configuration and setup prior to mounting. Note that you can complete the configuration and
setup procedures after mounting with a portable PC.
To connect the HMT140 to your network and view HMT140 data using viewLinc,
you require HMT140 Utility software and an HMT140 Configuration Cable (shipped
with viewLinc).
3.1.1 Opening Data Logger Cover
Figure 8 Opening Data Logger Cover
1. If the device is not mounted already, hold it against a flat surface.
2. Push on the cover with your thumb, and pull the bottom part of the cover towards
yourself.
Chapter 3 – Installation
19