Configuring The Hmt140 To Your Network - Vaisala HMT140 User Manual

HMT140 User Guide
4. Install three 3.6V lithium batteries. For the recommended battery type, see
Accessories (page
5. Turn the power switch on the device to the ON position, and wait for the setup process to
complete (five seconds). LED light turns on, then off.
4.1.3 Configuring the HMT140 to Your Network
After you install the HMT140 Utility and set up the HMT140, use the Configuration Cable and
HMT140 Utility software to connect and configure the HMT140 to your network.
To avoid depleting the battery power too quickly, make sure that your network is
on-line and available before configuring your device.
The following steps provide you with standard network settings. To set specific settings
depending on your network configuration, see
Follow the steps carefully. Do not connect the Configuration Cable to the HMT140
configuration port unless the Configuration Cable is connected to a computer
USB port, the batteries are installed, and the power switch is in the ON position.
To configure the HMT140 for your network with standard settings:
1. Make sure that the HMT140 cover is open and the correct batteries are installed.
2. Turn on the HMT140 and wait five seconds to make sure the startup process completes.
3. Plug the USB connector on the HMT140 Configuration Cable to the computer, if it is not
already connected.
4. From the Start menu, open the HMT140 Utility.
5. Connect the end of the HMT140 Configuration Cable labeled USB Wi-Fi Programmer to
the 4-pin HMT140 CONFIG header.
6. On the HMT140 Utility Setup tab, click Retrieve to identify the HMT140.
The bottom left status bar will initially read Looking for sensor or USB programmer, then,
once the HMT140 is identified, the status bar will read Found USB Programmer.
26
10).
Custom Settings (page
M211488EN-G
Options and
28).