JRR200 Route Reflector Quick Start
Have one person grasp both sides of the JRR200 route reflector, lift it, and position it in the rack so that the front mounting
2.
bracket holes align with the threaded holes in the rack rail and the second person secure the front of the JRR200 route reflector
to the rack by using rack-mounting screws (and cage nuts and washers if your rack requires them).
Continue to support the JRR200 route reflector, and have the second person slide the rear mounting blades into the channels
3.
of the side mounting rails and secure the blades to the rack. Use rack-mounting screws (and cage nuts and washers if your
rack requires them) to attach the sliding blades to the rack.
Connect the Grounding Cable
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to an approved site ESD
1.
grounding point. See the instructions for your site.
Connect one end of the grounding cable to a proper earth ground, such as the rack in which the JRR200 route reflector is
2.
mounted.
4
Copyright © 2018, Juniper Networks, Inc.