– fitting the soft-close mechanism
Insert soft-close mechanism on
the door hinge side (at an angle ini-
tially) so that it clicks into position.
Then press the other end of the soft-
close mechanism into the opening.
Secure the soft-close mechanism
with screw .
Push hinged arm into the opening
on the door hinge.
Insert pin into the door hinge from
above. Turn this with a screwdriver
(by approx. ¼ turn) until both lugs on
the pin click into position correctly in
the grooves.
Pull out red safety aid .
Tip: Keep the red safety aid in case you
want to change over the door hinging
again at a later date.
Fit cover on the door hinge.
Fit panel so that it clicks into posi-
tion.
1
Push on outer cover .
Close the appliance door.
Installation
85