Table of Contents
Advertisement
Message
The symbol lights up
in the display and an
alarm sounds.
lights up red in the
display and an alarm
also sounds.
Cause and remedy
You have selected the "Cleaning position " func-
tion, and the appliance has detected that the ice cube
drawer is full. The selected procedure is interrupted
and an alarm has sounded.
Touch in the display.
The alarm message is confirmed and the warning
tone stops.
The current temperature will appear in the display
again.
Empty the drawer, and then replace it in the appli-
ance.
There is a fault with the ice cube maker.
To switch the alarm off touch
Call Service.
To report the fault you need the fault code and also
the model number and serial number of your appli-
ance. You can access these in the display.
To do this touch in the display.
The appliance data required will be shown in the dis-
play.
Confirm with
OK
The ice cube maker can also be switched off in Set-
tings mode.
Problem solving guide
.
in the display.
71
Advertisement
Table of Contents
