Switching On And Off; Before Using For The First Time; Cleaning And Care; Operating The Wine Conditioning Unit - Miele KWT 6834 SGS Operating And Installation Instructions

Switching on and off

Before using for the first time

Packaging material
 Remove all packaging material from
the inside of the appliance.
Protective foil
Stainless steel surfaces have a layer of
protective foil to prevent scratching dur-
ing transportation.
 Do not remove the foil until the wine
conditioning unit has been positioned
in its final location. Start at one of the
top corners.

Cleaning and care

Please refer to the relevant instruc-
tions in "Cleaning and care".
 Clean the inside of the appliance and
the accessories.
18
Operating the wine condition-
ing unit
A light touch of the finger on the
sensors is all that is required to operate
this wine conditioning unit.
A tone will sound each time a sensor is
touched. You can deactivate this, if you
wish (see "Selecting further settings -
Audible tones").

Switching on

When the wine conditioning unit is con-
nected to the electrical supply, the
mains connection symbol  will ap-
pear in the display after a short while.
 Touch the On/Off sensor.
The mains connection symbol  will
go out and the wine conditioning unit
will start to cool.
The sensors for the upper, middle and
the lower wine conditioning zones will
then appear in the control panel. The
selected zone will be highlighted yellow
and the temperature of the selected
zone will show in the display.
The first time the appliance is switched
on the sensors for the wine conditioning
zones and the Alarm symbol  will
flash until the selected temperature has
been reached in the zones.