Miele KWT 6834 SGS Operating And Installation Instructions page 8

Warning and Safety instructions

The more coolant there is in a wine conditioning unit, the larger
the room it should be installed in. In the event of a leakage, if the ap-
pliance is in a small room, there is the danger of combustible gases
building up. For every 11 g of coolant at least 1 m
required. The amount of coolant in the appliance is stated on the
data plate inside the wine conditioning unit.

To avoid the risk of damage to the wine conditioning unit, make
sure that the connection data (fuse rating, frequency and voltage) on
the data plate corresponds to the household supply.
Check that this is the case before connecting the wine conditioning
unit. Consult a qualified electrician if in any doubt.

The electrical safety of the wine conditioning unit can only be
guaranteed when correctly earthed. It is essential that this standard
safety requirement is met. If in any doubt please have the electrical
installation tested by a qualified electrician.

Reliable and safe operation of the wine conditioning unit can only
be assured if it has been connected to the mains electricity supply.

If the electrical connection cable is faulty it must only be replaced
by a Miele authorised service technician to protect the user from
danger.

Do not connect the wine conditioning unit to the mains electrical
supply by a multi-socket adapter or extension lead. These are a fire
hazard and do not guarantee the required safety of the appliance.

If moisture gets into electrical components, it could cause a short
circuit. Therefore, do not operate this wine conditioning unit in areas
which are exposed to moisture (e.g in a garage or utility room).
8
3
of room space is