Display warnings
Message
The alarm symbol is
lit up in the display. The
three sensors for the
wine conditioning zones
are flashing in the con-
trol panel. An audible
alarm is also sounding.
The alarm symbol is
flashing in the display,
and the sensor for one
of the wine conditioning
zones is also flashing.
An audible alarm is also
sounding.
The Change Active
AirClean filter symbol
is lit up.
A dash is lit up up/flash-
ing in the display.
"F0" to "F3" or
"S1" to "S3" appear in
the display.
Cause and remedy
The door alarm has been activated.
Close the door. The three sensors for the wine
conditioning zones and the alarm symbol will
go out and the audible alarm stops.
The temperature in the zone concerned has risen
higher or fallen lower than the temperature set.
This could be due to:
– the appliance door being opened too often,
– blocked ventilation gaps,
– a lengthy interruption to the power supply.
Rectify the cause of the alarm. The alarm symbol
will go out and the sensor for the zone con-
cerned will light up constantly again. The audible
alarm stops.
This is the reminder to change the Active AirClean fil-
ters.
Replace the Active AirClean filters in all three wine
conditioning zones and then confirm the filter
change in settings mode (see "Active AirClean Fil-
ters").
Only temperatures within the range the wine condi-
tioning unit can display will be shown.
There is a fault.
Call Service.
Problem solving guide
49