Starting The Engine - Toro Workman 07390 Operator's Manual

CAUTION
If a load is concentrated near the back of the
cargo bed when you release the latches, the
bed may unexpectedly tip open, injuring you
or bystanders.
• Center loads in the cargo bed, if possible.
• Hold the cargo bed down and ensure that
no one is leaning over the bed or standing
behind it when releasing the latches.
• Remove all cargo from the bed before
lifting the bed up to service the machine.
Move the lever rearward to raise the cargo bed
(Figure 21).
Figure 21
1. Cargo bed lever
Lowering the Cargo Bed
WARNING
The weight of the bed may be heavy. Hands
or other body parts could be crushed.
Keep your hands and other body parts away
when lowering the bed.
Move the lever forward to lower the cargo bed
21).
Opening the Tailgate
1. Ensure that the cargo bed is down and latched.
2. Open the latches on the left and right side of the
cargo bed and lower the tailgate
1. Latch handle
2. Latch gate

Starting the Engine

Important:
g024612
machine to get it started. Damage to the drive
train could result.
1.
2.
3.
4.
5.
(Figure
6.
(Figure 22).
26
Figure 22
Do not attempt to push or tow the
Sit on the operator seat and engage the parking
brake.
Disengage the PTO and the high-flow hydraulics
(if equipped) and move the hand-throttle lever to
the O position (if equipped).
FF
Move the transmission lever to the P (P
position.
Ensure that the hydraulic-lift lever is in the O
position (center).
Press the brake pedal.
Note:
Keep your foot off the accelerator pedal.
Insert the key into the key switch and rotate it
clockwise to start the engine.
Note:
Release the key switch when the engine
starts.
Note:
The oil-pressure warning light should
turn off.
Important:
To prevent overheating of the
starter motor, do not engage starter longer
than 15 seconds. After 15 seconds of
g026141
3. Latch pin
)
ARK
FF