Toro Workman 07390 Operator's Manual page 60

Figure 79
Hydraulic-fluid level (non-TC models)
1. Cap 2. Dipstick
Figure 80
Hydraulic-fluid level (non-TC model with the High Flow
Hydraulic Kit (optional kit) or TC model)
1. Cap 2. Dipstick
5.
6.
7.
8.
g024249
3. Filler neck
g024250
3. Filler neck
60
Remove the cap and dipstick from the filler neck
of the reservoir and wipe the dipstick clean with
a rag (Figure 79 and Figure
Insert the dipstick into the filler neck; then
remove it and check the fluid level
and Figure 80).
•
Non-TC model: The hydraulic-fluid level
should be between the lower indented area
on the dipstick.
•
Non-TC model with the
High-Flow-Hydraulic Kit (option) or
TC model: The hydraulic-fluid level should
be between the upper indented area on the
dipstick.
If the level is low, add the specified hydraulic
fluid into the reservoir to raise the level to the
middle of the indented area on the dipstick
(Figure 79 and Figure
Install the dipstick and cap to the filler neck of
the reservoir (Figure 79
80).
(Figure 79
80).
and Figure 80).