Toro Workman 07390 Operator's Manual page 51

3. Remove the 6 hex-washer screws (#10 x 3/4
inch) that secure the control-cover plate to the
seat base, and remove the cover plate
60).
4. Move the speed-range lever to the T
( ) position
TRANSPORT
5. Loosen the 2 hex-socket screws (5/16 x 3/4 inch)
that secure the detent plate to the lever-support
bracket (Figure 62).
Figure 62
1. Lever-support bracket
2. Hex-socket screws
6. Move the detent plate in one of the following
directions:
•
Move the detent plate forward to increase
the maximum ground speed limit
•
Move the detent plate rearward to decrease
the maximum ground speed limit
7. Tighten the 2 hex-socket screws (5/16 x 3/4
inch) to 19.8 to 25.4 N∙m (14.6 to 18.7 ft-lb).
8. Drive the machine with the speed control set
to speed range for which you are setting the
maximum ground speed limit. If the maximum
ground speed limit is too fast or too slow, repeat
steps 1 through 8
ground speed limit is attained.
9. Align the holes in the control-cover plate to the
holes in the seat base
10. Secure the plate to the base with the 6
hex-washer screws
removed in step 3.
11. Thread the knobs onto the rods for the
hydraulic-lift lever and the speed-range lever
(Figure 60).
(Figure
(Figure 62).
3. Detent plate
(Figure
(Figure
until the correct maximum
(Figure 60).
(Figure 60) that you
Checking the Drive Belt
Service Interval: Every 400 hours
1. Remove the 9 hex-washer bolts (1/4 x 1 inch)
that secure the transmission cover to the
mounting plate of the transmission
g025550
1. Hex-washer bolts (1/4 x 1
inch)
2. Transmission cover
3. Drive belt
62).
2. Move the cover forward until you can see the
drive belt
62).
3. Check the tapered faces of the primary clutch
for signs if damage
Note:
If the faces of the primary clutch are
damaged, replace the primary clutch; contact
your Authorized Service Dealer.
4. Check the drive belt for missing or damaged
cogs (Figure
Note:
If the cogs of the drive belt are missing or
damaged, replace the drive belt.
5. Measure across the belt and record the belt
width (Figure
Note:
If the width of the belt is 29.5 mm (1.16
inches) or less, replace the belt
6. Align the holes in the transmission cover with
the holes in the mounting plate
7. Secure the cover to the mounting plate
63) with the 9 hex-washer bolts (1/4 x 1 inch)
51
Figure 63
4. Mounting plate
5. Tapered faces (primary
clutch)
6. Belt width—replace at
29.5 mm (1.16 inches) or
less
(Figure 63).
(Figure 63).
63).
63).
(Figure
(Figure
(Figure 63).
g025548
63).
63).
(Figure