Toro Workman 07390 Operator's Manual page 63

3. On the disabled machine, connect the 2 jumper
hoses to the hoses that were disconnected
(Figure 84).
4. Cap the unused fittings.
1. Disconnected hoses
5. On the other machine, connect the 2 hoses to
the coupler still in the coupler bracket (connect
the top hose to the top coupler and the bottom
hose to the bottom coupler)
6. Cap the unused fittings.
1. Jumper hoses
7. Keep all bystanders away from the machines.
8. Start the second machine and move the lift lever
to the raise position, which raises the disabled
cargo bed.
9. Move the hydraulic-lift lever to the N
position, and engage the lift-lever lock.
10. Install the bed support onto the extended lift
cylinder; refer to
35).
Note:
With both the machine turned off, move
the lift lever back and forth to remove the system
pressure and ease the disconnection of the
quick couplers.
Figure 84
2. Jumper hoses
(Figure 85).
Figure 85
EUTRAL
Using the Bed Support (page
11. After completing the operation, remove the
jumper hoses and connect the hydraulic hoses
to both machines.
Important:
levels, in both machines, before resuming
operation.
g002429
g019543
63
Check the hydraulic fluid