Table of Contents
Advertisement
06.91
7
Configuration and Test
The SINUMERIK 8X0 computer link uses an identical configuration and test concept for both
bus and point-to-point connection.
The connections and the SINUMERIK-specific message frames are defined on configuration.
The configuring data is stored in lists on the interface module.
It is possible to record for test purposes message frames within the SINUMERIK or on the
transmission medium - bus cable or serial connection cable.
Furthermore, test devices are available with which either the control system or the computer
part in sessions between control system and computers can be simulated.
7.1
Configuration
The following table gives an overview of the available configuration means which support
configuration of the bus interface module and the serial interface module. They are used to
define the connections and to generate the SINUMERIK-specific lists.
Config. means
Config.
device
SINEC NM
PG685T
(Network
Management)
SINEC NML
PG685/
(Network
PG685T
Management
PG 750
Local)
SINPS231
PG685/
(SINUMERIK
PG685T
Configuring
PG 750
service)
SINPS315
PG685/
(SINUMERIK
PG685T/
Configuring
PC AT
service)
PG 750
© Siemens AG 1989 All Rights Reserved
SINUMERIK 840/880 (PJ)
Application
CP 231
CP 315
X
Configuration of the SINEC interface modules in
the local area network via the SINEC H1 bus from
the central configuring station.
X
Configuration of the SINEC interface module via
the programmer interface of the SINEC interface
module or via the SINEC H1 bus from a local
configuring station.
X
Generation of the SINUMERIK-specific lists (input
list 1, output list 1, format list) for the bus interface
module.
X
Generation of the SINUMERIK-specific lists (input
list 1, output list 1, format list) and connection-
oriented lists (list of interfaces, addressing list) for
the serial interface module.
6FC5 197-0AB20-0BP0
7 Configuration and Test
7.1 Configuration
Task
7–1
Advertisement
Table of Contents
