Sinps 231 - Siemens SINUMERIK 840 Planning Manual

7 Configuration and Test

7.1.3 SINPS 231

7.1.3 SINPS 231
SINPS 231 (SINUMERIK configuration service for CP 231) is a software package with which
the SINUMERIK-specific configuring data (input list 1, output list 1, format list) is generated.
This software runs on PG 685 and PG 685 T and is used together with the SINEC NM or
SINEC NML software packages (see figures "Central configuration" and "Local
configuration").
Via a communication file the SINUMERIK-specific configuration is linked to the SINEC
configuration.
Input list 1, output list 1 and the format list are generated by SINPS 231. In these lists the
information is stored by means of which the SINUMERIK driver interprets and/or generates the
SINUMERIK-specific part of the message frames.
The lists are stored on the interface module.
Input list 1
In input list 1, for incoming message frames, the characters 1 to 6 of the identification and the
sub-address are related to a function number, the SINUMERIK-internal addressing data and
the format identifier. The figure "Structure of input list 1" shows the entries of input list 1 as an
example for two message frames of the synchronization session.
The search key in input list 1 consists of characters 1 to 6 of the identification and the sub-
address.
Example: Synchronization session (automatic synchronization by production control)
ID Sub-address Max.
1-6 pos. length length
useful.
data
Mess.fr.
T-SY -- -- 10
No. 1
Mess.fr.
T-SP -- -- 14
No. 3
• • • •
• • • •
• • • •
Configuration of input list 1 for two message frames of the synchronization session
Structure of input list 1
7–4
Fct. Cont. Log. Locat. Type
no. sub- part. receiver receiv.
addr. dest.
e.g.
11 -- GLOB PLC1 S
e.g. e.g.
150 -- GLOB PLC1 P
• • • • •
• • • • •
• • • • •
© Siemens AG 1989 All Rights Reserved
Addr.. Addr Form.
user DB/DX DW ident.
-- -- -- --
e.g. e.g. e.g. e.g.
20 DB240 DW10 SYNCH
• • • •
• • • •
• • • •
S: Standard
P: User, configurable
6FC5 197-0AB20-0BP0
SINUMERIK 840/880 (PJ)
08.89