Table of Contents
Advertisement
11.92
7.2
Test and simulation
For the installation, initial tests and fault detection, various test means are available which are
used for simulation and monitoring (see figures "Test configuration for SINEC H1 bus" and
"Test configuration for point-to-point connection"). The following table gives an overview of the
test services offered.
Test means
Test
device
SINT (SINUMERIK
PG 685 /
test software)
PG 685T
PG 750
PC AT
SIM 850
PC 16-11
PC 16-20
WS 20-32
FOX PG-S
PG 675 /
PG 685
FOX-PGM
PG 675/
PG 695
SIPRA H1(SINEC
PG 685 /
Protocol Analyzer)
PG 695
The configuring data can be stored with the SINT software on the
EPROM system module of the CP 231A or CP 315.
Further explanations are available in the following documentation:
SINUMERIK 840/880
Computer Link
Test software SINT
© Siemens AG 1989 All Rights Reserved
SINUMERIK 840/880 (PJ)
Application
CP 231
CP 315
X
X
Configuring, read-out and interpreting the trace
buffers available on the interface modules.
X
X
Simulation of the interface session between
SINUMERIK 8X0 and production control computer
for bus and point-to-point connection.
X
Simulation of the interface session between
SINUMERIK 8X0 and production control computer
for point-to-point connection.
X
Monitoring the message frame traffic on the serial
transmission line for point-to-point connection.
X
Recording the activity on the SINEC H1 bus.
Planning Guide
6FC5 197-0AB20-0BP0
7 Configuration and Test
7.2 Test and simulation
Task
7–11
Advertisement
Table of Contents
