Zephyr Ombra Use, Care And Installation Manual page 8

D
n .
m i
E
n .
m i
x . F
m a
3 6
Standard
Hood Heights Duct Cover
minimum ducted (A) 27-1/2"
minimum recirculating (B) 32"
maximum (C) 42-1/2"
Ceiling Heights
minimum ducted (D) 89-1/2" (7' 5-1/2") 108-1/2" (9' 1/2")
minimum recirculating (E) 94" (7' 10")
maximum (F) 112-1/2" (9' 4-1/2")150" (12' 6")
DUCTING
A minimum of 6" round duct is recommended to
Always use rigid type metal ducts only. Flexible
ALWAYS, when possible, reduce the number of
transitions and turns. If a long duct run is required,
increase duct size from 6" to 7".
If turns or transitions are required: Install as far
away from opening and as far apart, between 2,
A
n .
m i
B
as possible.
n .
m i
x . C
m a
Minimum mount height between range top to hood
bottom should be no less than 26".
i n . Maximum mount height should be no higher than
" m a x .
2 6 34".
" m
3 4
It is important to install the hood at the proper
mounting height. Hoods mounted too low could
mounted too high will be hard to reach and will
"
If available, also refer to range manufacturer's
height clearance requirements and recommended
Extension
Duct Cover
heights up to 12 feet. Turn to page 12 for part
46-1/2"
number and ordering information.
50-1/2"
80"
112-1/2" (9' 4-1/2")
DAMAGE-SHIPMENT / INSTALLATION:
• Please fully inspect unit for damage before
installation.
• If the unit is damaged in shipment, return the
unit to the store in which it was bought for
repair or replacement.
• If the unit is damaged by the customer, repair
or replacement is the responsibility of the
customer.
be made by arrangement between customer
and installer.
6
www.zephyronline.com