INSTALLATION DUCTING WARNING: FIRE HAZARD NEVER exhaust air or terminate duct work into spaces between walls, crawl spaces, ceiling, attics or garages. All exhaust must be ducted to the outside. Use Metal ductwork only. Fasten all connections with sheet metal screws and tape all joints w/ certified Silver Tape or Duct Tape.
INSTALLATION SPECIFICATIONS 10.47" 13.77" ELECTRICAL WARNING: All Electrical work must by performed by qualified electrician or person with similar technical know how and background. For personal safety, remove house fuse or open circuit breaker before beginning installation. Do not use extension cord or adapter plug with this appliance. Follow National electrical codes or prevailing local codes and ordinances.
1. Purchase ductless Charcoal Filters as follow: Hood Model: Part No. Filters in pkg. ZMI-M90G/S Z0F-C022 2. Remove metal filters on hood. Clip carbon filters onto each slot opening. 3. Re-install metal filters. 4. Turn on Filter Change Indicator on control panel (refer details pg.
FEATURES & CONTROLS TOUCH CONTROLS & FEATURES Blower On/Off Adjust 6 Speed Levels Blower On/Off By pressing , the blower is switched On and Off. When switched on, the blower starts up on speed level 3. Speed Selection The 6 speed levels are selected by pressing display indicates level selected.
FEATURES & CONTROLS CONTROLS: FILTER CHANGE INDICATOR (Carbon Filters) Filter Change Reminder (Carbon, if fitted): When your hood is installed as a 'Purifying' (Ductless Recirculating) unit, it is fitted with a set of Carbon Filters to purify exhaust and fumes from cooking, and re-circulates the air within the home.
Page 11
FEATURES & CONTROLS CONTROLS: FILTER CLEAN INDICATOR (Metal Filters) Filter Clean Reminder (Standard Metal Filters fitted) Whether your hood is installed as an Exhaust or Purifying unit, a set of metal filters are fitted by the factory. These Metal Filters are intended to filter out residue from cooking. It need not be replaced on a regular basis but are required to be kept clean.
Replacing Metal Filters Should filters wear out due to age and prolonged use, replace with following part number: Hood Model: Part No. Filters in pkg. ZMI-M90G/S Z0F-M022 Also replace damaged filter that has punctured or broken mesh, bent or broken frame.
Page 13
MAINTENANCE LIGHTS Replacing Light Bulbs CAUTION: Light bulb becomes extremely hot when turned on. DO NOT touch bulb until switched off and cooled. Touching hot bulbs could cause serious burns. Make sure all power is turned off and bulbs are not hot. Remove by turning bulb counter clockwise.
Page 14
Damaged because of improper connection with equipment of other manufacturers. Repaired or modified by anyone other than Zephyr's Authorized Agents. What is Not Covered: Consumable parts such as light bulbs, filters, and fuses.