Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zephyr Range Hood APN-M90AWX
Summary of Contents for Zephyr Range Hood APN-M90AWX
- Page 1 www.zephyronline.com Plane APN-M90ABX APN-M90AWX...
- Page 2 www.zephyronline.com HOTTE PER CUISINE - Notice d’utilisation...Pag. 21 CAMPANA EXTRACTORA - Manual de utilización...Pag. 41 CAPPA ASPIRANTE - istruzioni per l’uso...Pag. 61 - 2 -...
-
Page 3: Table Of Contents
SAFETY INSTRUCTIONS...pag. 4 LIST OF MATERIALS...pag. 7 DUCTING CALCULATION SHEETS...pag. 8 HOOD SPECIFICATION...pag. 9 INSTALLATION - INTERNAL BLOWER...pag. 10 - EXTERNAL & IN-LINE BLOWER PREPARATION...pag. 12 - DUCTING OPTIONS...pag. 14 - POWER SUPPLY CONNECTION...pag. 16 - MOUNTING THE RANGE HOOD...pag. 17 MAINTENANCE...pag. -
Page 4: Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS FOR RESIDENTIAL USE ONLY READ AND SAVE THESE INSTRUCTIONS PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING. IMPORTANT: Save these Instructions for the Local Electrical Inspectors use. INSTALLER: Please leave these Instructions with this unit for the owner. OWNER: Please retain these instructions for future reference. Take care when using cleaning agents or detergents. - Page 5 settings. B. Always turn hood ON when cooking at high heat or when fl ambeing foods ( i.e. Crepes Suzette, Cherries Jubilee, Peppercorn Beef Flambè ). C. Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or fi lter. D.
- Page 6 www.zephyronline.com through the fl ue (chimney) of fuel burning equipment to prevent back drafting. Follow the heating equipment manufacturer’s guideline and safety standards such as those published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities.
-
Page 7: List Of Materials
Duct Cover Bracket Duct Covers Control Glass Electrical Junction Box Range Hood Body Light Bulbs Decorative Mesh Filters (12) 1/4" (1+1) M4 - 7 -... -
Page 8: Ducting Calculation Sheets
www.zephyronline.com Maximum Duct Length: For satisfactory air movement, the total duct length should not exceed 100 equivalent feet. - 8 -... -
Page 9: Hood Specification
side of hood front of hood top of hood - 9 -... -
Page 10: Internal Blower
The following instructions are for installing the internal blower. CAUTION: To reduce the risk of fi re and electric shock, install this range- hood only with internal blower models MT-017 provided with the kit cod CBI-600A. For external and in-line blower prepa- ration please turn to page 12. - Page 11 6. Attach the 6 pin male molex connector from blower wire to the 6 pin female molex connector located inside the blower housing. See Fig.6 7. Install blower and blower plate into blower housing by following the reverse instructions from step 2. See Fig.7 8.
-
Page 12: External & In-Line Blower Preparation
The following instructions are for preparing the hood for use with an ex- ternal or in-line blowers models CBE-1000 or PBN-1000A. CAUTION: To reduce the risk of fi re and electric shock, install this rangehood only with remote blowers rated maximum 6.2 A. For internal blower instructions please turn to page 10. - Page 13 6. Insert the 6 pin female molex connector into the junction box. See Fig. 6A. Secure remote blower junction box to top of blower housing using (2) screws. See Fig. 6B 7. Feed remote blower wire harness through remote blower junction box cover and Connect the wires with those inside the junction box.
-
Page 14: Ducting Options
www.zephyronline.com WARNING FIRE HAZARD NEVER exhaust air or terminate duct work into spaces between walls, crawl spaces, ceiling, attics or garages. All exhaust must be ducted to the outside, unless using the recirculating op- tion. Use single wall rigid Metal ductwork only. Fasten all connections with sheet metal screws and tape all joints w/ certif ed Silver Tape or Duct Tape. - Page 15 MOUNTING HEIGHTS The range hood must be installed at a minimum eight of 24 inches (71cm) from the cooking surface. If a connecting duct work composed of two parts is used, the upper part must be placed outside the lower part. Do not connect he range hood duct to the same duct used to exhaust hot air or fumes from another appliance.
-
Page 16: Power Supply Connection
GENERAL • Carefully read the following important information regarding installation safety and maintenance. Keep this information booklet accessible for further consultations. POWER SUPPLY CONNECTION For connection to the power supply refer to the following: 1. Lift the bottom part of the duct cover and secure it carefully using adhesive tape. -
Page 17: Mounting The Range Hood
MOUNTING THE DUCT COVER 1. Install the electrical wiring and test hood for functions prior to installing the duct covers. 2. If using hood in air recirculating mode make sure to install the air diverter plate prior to mounting the duct covers. See the manual included with the recirculating kit for more instructions. -
Page 18: Maintenance
www.zephyronline.com MAINTENANCE • It is recommended to operate the appliance prior to cooking. It is recommended to leave the appliance in operation for 5 minutes after cooking is completed in order to completely eliminate cooking vapors and odors. The proper function of the range hood is conditioned by the regularity of maintenance. -
Page 19: List Of Parts And Accessories
DESCRIPTION REPLACEMENT PARTS Light Bulb GU4, 20W (each) OPTIONAL ACCESSORIES Recirculating Kit Replacement Charcoal Filters APN Duct Cover Extension To order parts, visit us online at http://store.zephyronline.com or call us at 1.888.880.8368 HOOD Z0B0030 ZRC-00PN Z0F-00AC Z1C-00PN - 19 - PART#... - Page 20 www.zephyronline.com - 20 -...