Sony DCR-TRV950 Network Function Operating Instructions Manual page 190

Connecting your camcorder to your computer using the USB cable
– For Windows users
(11) Follow the on-screen messages so that the Add Hardware Wizard recognizes
For Windows 2000 Professional, Windows XP Home Edition/Professional users
(12) After the "File Needed" screen appears.
Viewing images recorded on a "Memory Stick"
Set USBCONNECT in
to NORMAL.)
(1) Insert a "Memory Stick" into your camcorder.
(2) Connect the AC power adaptor and set the POWER switch to MEMORY/
(3) Connect the
(4) Follow the on-screen messages to make the Add Hardware Wizard recognize
You cannot install the USB driver if a "Memory Stick" is not in your camcorder.
Be sure to insert a "Memory Stick" into your camcorder before installing the USB
driver.
190
that the USB drivers have been installed. The Add Hardware Wizard starts
three times because three different USB drivers are installed. Be sure to allow
the installation to complete without interrupting it.
Open "Browse..." t "My Computer" t "ImageMixer" t "Sonyhcb.sys",
and click "OK."
NETWORK (DCR-TRV950 only).
(USB) jack on your camcorder to the USB connector on your
computer using the supplied USB cable.
USB MODE appears on the LCD screen of your camcorder. Your computer
recognizes the camcorder, and the Add Hardware Wizard starts.
(USB) jack
Push into the end
that the USB drivers have been installed. The Add Hardware Wizard starts
two times because two different USB drivers are installed. Be sure to allow
each installation to complete without interrupting it.
to NORMAL in the menu settings. (The default setting is set
USB connector
USB cable (supplied)