Sony DCR-TRV950 Network Function Operating Instructions Manual page 117

Audio dubbing
Adding audio on a recorded tape
Choose a connection described on the previous pages, and connect audio equipment or
microphone to your camcorder. Then follow the procedure below.
(1) Insert the recorded tape into your camcorder.
(2) Set the POWER switch to VCR on your camcorder.
(3) Locate the recording start point by pressing N. Then press X at the point
where you want to start recording to set your camcorder to the playback
pause.
(4) Press AUDIO DUB . The green
(5) Press X and start playing back the audio you want to record at the same time.
The new sound is recorded in stereo 2 (ST2) during playback. While audio is
being recorded, the red
(6) Press x at the point where you want to stop recording.
AUDIO DUB
When you dub the recorded sound
You can adjust the recorded sound by using MIC LEVEL (p. 79). However, when the
camcorder is connected to the AUDIO/VIDEO jack, sound cannot be adjusted.
To add audio more precisely
Press ZERO SET MEMORY on the Remote Commander at the point where you want to
stop recording later in the playback.
Carry out from steps 3 to 5. Recording automatically stops at the point where ZERO
SET MEMORY was pressed.
X indicator appears on the screen.
appears on the screen.
AUDIO DUB
117