Replace The Stator And Rotor - WAGNER PLAST COAT HP 30 Operating Manual

Plast Coat HP 30
9.4

REPLACE THE STATOR AND ROTOR

Machine must be depressurised.
If necessary, set the selector switch briefly
to "R" (reverse).
Watch the manometer ––> 0 bar.
Wear safety goggles.
Disassembly may only be carried out by
the person who controls the machine.
Never operate machine with an exposed
rotor.
Do not reach into the rotor when it is mov-
ing. Risk of crushing.
Caution if you have long hair. Only wear
close-fitting clothes at work.
• Move selector switch (fig. 9, 1) to "0" and set pressure regula-
tor (2) to „0".
• Disconnect mains plug.
• Disconnect the control cable (Fig. 10, 1) on the pump unit.
• Loosen the 3 nuts (Fig. 11, 3) on the outlet unit (4) and sepa-
rate the outlet unit from the old stator (5).
• Lift the feed helix (Fig. 12, 6) with the hook tool (7) and sus-
pend the old rotor / stator combination (5).
• Lift the feed helix (Fig. 12, 6) with the hook tool (7), insert the
new rotor / stator combination (5) and suspend it in the feed
helix.
• Reinsert the outlet unit and secure in place with the 3
screws.
• Connect the control cable.
POWER ERROR
PRESSURE
1 2
1
7
6
GB
MAINTENANCE
4
3
5
5
37