WAGNER PLAST COAT HP 30 Operating Manual page 28

GB
SAFETY REGULATIONS
Whenever the machine is automatical-
ly brought to a standstill or during pow-
er failure, immediately move the selec-
tor switch to "0" to prevent the machine
starting back up again unintentionally.
There is a danger of injury.
High Pressure Hose
Attention, danger of injury by injection! Wear
and tear and kinks as well as usage that is not
appropriate to the purpose of the device can
cause leakages to form in the high-pressure
hose. Liquid can be injected into the skin
through a leakage.
High-pressure hoses must be checked thoroughly before
they are used.
Replace any damaged high-pressure hose immediately.
Never repair defective high-pressure hoses yourself!
Avoid sharp bends and folds: the smallest bending radius
is about 20 cm.
Do not drive over the high-pressure hose. Protect against
sharp objects and edges.
Never pull on the high-pressure hose to move the device.
Do not twist the high-pressure hose.
Do not put the high-pressure hose into solvents. Use only
a wet cloth to wipe down the outside of the hose.
Lay the high-pressure hose in such a way as to ensure that
it cannot be tripped over.
Only use WAGNER original-high-pressure
hoses in order to ensure functionality, safety
and durability.
The risk of damage rises with the age of the
high-pressure hose.
Wagner recommends replacing high-pres-
sure hoses after 6 years.
28
Setup on an uneven surface
The machine must be installed as shown in the diagram below
to prevent it slipping (outlet unit pointing downwards). Block
front wheels with brakes.
Plast Coat HP 30